Disclaimer: PH Custromz is not responsible for any damage caused to you or your bike. This modification is only an attempt to minimze the risk of damage. It will not completly eliminate any chances of damages occuring in any way.
This was performed on my 1998 Honda Foreman 450S, The steps should hold true for most hondas.
Here are the few simple steps to sealing off the Recoil pull starter.
This way you can seal it off from dirt and water minimizing their chances of causing damage. Plus you will still reatain the use of the pull stater if it is ever needed.
Pull starter's location on the bike. Rear of motor, in front of the swingarm. Remove the bolt's that hold's it on and remove from the bike. apply RTV on the back of the recoil sealing area. Including where the pull cord handle fits into the case and where the rope goes into the handle also. There also may be a weephole in the bottom of the casing. If your has one seal that up as well.
-- Edited by Badforeman475 at 10:39, 2009-01-17
__________________
98 Foreman 450 DGL 14% GR 475BBK Snorkle S-I-G Mod HL Springs Jetted Uni Filter Glass Pack Relocated Fan/Oil Cooler 28" SilverBacks on SS112's Coming 35% GR 30's or 32's Backs A Big IRS Lift
